• July 14. 2021

To ensure the AC drive functions reliably, proper considerations must be given to installation such as the specification of the motor, incoming, outgoing cables and the environmental parameter it operates in. As with any electrical types of equipment, AC drives can deteriorate after prolonged use even if it was installed properly. It helps to spot signs of imminent damage on the AC Drive early on ...

• July 16. 2021

The following fault code will be displayed on the operation panel, the fault contact output operates, and the output to motor is disable, the motor will coast to stop. For details, refer to the following table to identify and correct the cause of the fault. Fault No. Fault display on panel Fault description Possible causes Corrective actions 1 E.oc1 Over current during acceleration Low grid voltag...

• July 20. 2021

The following fault code will be displayed on the keypad, the fault contact output operates too. Even if a fault is the same, they are displayed differently on LCD keypad and LED keypad. These are all explained in the below table. For details, refer to the following table to identify and correct the cause of the fault. LCD keypad LED keypad F0−15 value Fault Name Possible causes Corrective actions...

• July 22. 2021

Fault number Fault Code Fault Description Possible Causes Countermeasure 1 E.oc1 Over current protection when acceleration operation Low grid voltage Check input power supply Startup during motor free rotation Restart after the motor standstill Rotating inertial of load is too large or shock load is too heavy Increase the acceleration time and reduce the sudden change of load Improper setting moto...

• July 26. 2021

FV20−M serial inverter is equipped with complete protection functions to provide efficient protection while utilizing its performance sufficiently. Some failure instructions may be displayed during operation. Compare the instructions with the following table and analyze,assess the causes and solve failures. Failure No. Failure code Failure description Potential causes Solutions Number 01 E. SC Out...

• July 28. 2021

This chapter lists all the faults messages including the possible causes and corrective actions. If the drive faults, the drive output is disabled so that the drive stops controlling the motor, and the following fault code will be displayed on the keypad, the fault contact output operates too. Even if a fault is the same, they are displayed differently on LCD keypad and LED keypad. These are all e...

• August 06. 2021

Once a fault is detected, the following fault code will be displayed on the operation panel, the fault contact output operates, and the output to motor is disable, the motor will coast to stop. For details, refer to the following table to identify and correct the cause of the fault. Fault No.  Fault display on panel Fault description Possible causes Corrective actions 1 E.oc1 Over c...

• August 09. 2021

FAQ I. Why have abnormal operation in vector control 2 without encoder speed feedback? (1) Check if there exists large difference between the motor rated current and inverter rated current (2) Check if complete motor data identification has been performed (3) Check if the lines for Hall sensor is loosen or dislocated for V5−H−4T18.5G/22L and above power class II. Why have abnormal operation in vec...